A Holybro cable run with a JST GH 10-pin connector at one end and a 6-pin connector at the other, 300mm long. JST GH connectors are the small locking connectors used on flight controllers and peripherals, and their value is the latch: unlike a plain header, a GH connector cannot rattle off in flight.
Adapting from a 10-pin to a 6-pin is what this cable is for — flight controller connectors vary between boards and firmware standards, and a cable that steps from one pin count to another is what allows two components with different connectors to be connected without cutting and soldering.
300mm of length gives enough to route a run between two boards mounted separately. Supplied as five sets, and this listing is seven packs of that — a workshop quantity rather than a single cable.
Reviews
There are no reviews yet.